PenangAPRS Track

My position About ☰

reset

CE3SUR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CE3SUR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Sate*	Temp*	Volt*	Alt*
1780180156	12	810 C	415 V	51 M
1780179127	12	816 C	415 V	50 M
1780178921	12	811 C	408 V	50 M
1780174812	12	817 C	415 V	54 M
1780173822	12	811 C	414 V	51 M
1780169597	12	796 C	409 V	51 M
1780165394	12	778 C	415 V	53 M
1780162360	12	748 C	415 V	51 M
1780161703	12	732 C	415 V	51 M
1780157916	12	705 C	416 V	50 M
1780156799	12	693 C	416 V	52 M
1780152595	12	693 C	416 V	50 M
1780148210	12	675 C	416 V	51 M
1780144007	12	677 C	416 V	51 M
1780139824	12	679 C	415 V	51 M
1780135385	12	687 C	416 V	51 M
1780131181	12	693 C	416 V	53 M
1780126974	12	703 C	415 V	51 M
1780122772	12	713 C	415 V	52 M
1780118568	11	718 C	407 V	53 M
1780114363	12	738 C	414 V	51 M
1780110153	12	748 C	416 V	52 M
1780105948	12	756 C	416 V	50 M
1780103301	12	771 C	415 V	51 M
1780102970	12	769 C	414 V	51 M

*Used Equation Coefficients:

Sate: 0, 1, 0

Temp: 0, 1, 0

Volt: 0, 1, 0

Alt: 0, 1, 0

A5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)