PenangAPRS Track

My position About ☰

reset

XQ3PCN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XQ3PCN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1794335136	75 Count	1003 Count
1794334232	74 Count	968 Count
1794333328	73 Count	934 Count
1794332517	72 Count	894 Count
1794331613	64 Count	850 Count
1794330709	63 Count	807 Count
1794329806	62 Count	764 Count
1794328902	61 Count	725 Count
1794327998	53 Count	680 Count
1794327094	52 Count	659 Count
1794326191	51 Count	621 Count
1794325287	50 Count	593 Count
1794324383	44 Count	564 Count
1794323479	43 Count	529 Count
1794322575	42 Count	480 Count
1794321671	41 Count	445 Count
1794320767	33 Count	429 Count
1794319863	32 Count	390 Count
1794318960	31 Count	359 Count
1794318056	30 Count	327 Count
1794317152	22 Count	298 Count
1794316247	21 Count	256 Count
1794315344	20 Count	213 Count
1794314440	19 Count	171 Count
1794313536	11 Count	158 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)