PenangAPRS Track

My position About ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1773722617	1 Count	104 Count
1773720815	0 Count	51 Count
1773719017	23 Count	1004 Count
1773717216	22 Count	947 Count
1773715414	21 Count	890 Count
1773713613	20 Count	847 Count
1773712347	19 Count	847 Count
1773710545	18 Count	795 Count
1773708744	16 Count	742 Count
1773706943	15 Count	695 Count
1773706908	14 Count	695 Count
1773705106	13 Count	645 Count
1773703278	12 Count	599 Count
1773701477	11 Count	556 Count
1773699676	10 Count	512 Count
1773697875	9 Count	468 Count
1773697838	8 Count	468 Count
1773696037	7 Count	424 Count
1773694236	6 Count	384 Count
1773692439	5 Count	348 Count
1773690637	4 Count	307 Count
1773688836	3 Count	245 Count
1773687035	2 Count	190 Count
1773685239	1 Count	140 Count
1773683437	0 Count	95 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)