PenangAPRS Track

My position About ☰

reset

LW2DHT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794329588	388 Count	426 Count	311 Count
1794327785	382 Count	420 Count	306 Count
1794325982	376 Count	414 Count	301 Count
1794324179	370 Count	407 Count	296 Count
1794322376	364 Count	400 Count	291 Count
1794320573	359 Count	393 Count	287 Count
1794318770	354 Count	387 Count	283 Count
1794315197	338 Count	374 Count	273 Count
1794313394	334 Count	368 Count	270 Count
1794311591	328 Count	361 Count	265 Count
1794309788	321 Count	353 Count	259 Count
1794307985	315 Count	347 Count	254 Count
1794306182	309 Count	340 Count	249 Count
1794304379	303 Count	334 Count	244 Count
1794302576	297 Count	327 Count	239 Count
1794300773	290 Count	320 Count	233 Count
1794298970	284 Count	313 Count	228 Count
1794297167	278 Count	307 Count	223 Count
1794293594	262 Count	294 Count	213 Count
1794291792	256 Count	287 Count	208 Count
1794289988	250 Count	280 Count	203 Count
1794288185	244 Count	274 Count	198 Count
1794286382	238 Count	268 Count	193 Count
1794284579	232 Count	261 Count	188 Count
1794282776	226 Count	254 Count	183 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)