PenangAPRS Track

My position About ☰

reset

F4FWW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4FWW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1774212317	539 Count	421 Count	240 Count
1774210517	537 Count	419 Count	239 Count
1774208716	536 Count	419 Count	239 Count
1774206915	534 Count	418 Count	238 Count
1774205115	533 Count	418 Count	238 Count
1774203314	531 Count	416 Count	237 Count
1774201513	529 Count	415 Count	236 Count
1774199712	528 Count	415 Count	236 Count
1774197920	526 Count	414 Count	235 Count
1774196119	524 Count	413 Count	234 Count
1774194319	522 Count	411 Count	233 Count
1774192518	520 Count	408 Count	232 Count
1774190717	518 Count	407 Count	231 Count
1774188917	516 Count	405 Count	230 Count
1774187116	514 Count	404 Count	229 Count
1774185315	512 Count	402 Count	228 Count
1774183515	510 Count	399 Count	227 Count
1774181714	508 Count	395 Count	226 Count
1774179913	506 Count	392 Count	225 Count
1774178113	504 Count	389 Count	224 Count
1774176320	502 Count	386 Count	223 Count
1774174519	501 Count	386 Count	223 Count
1774172718	500 Count	386 Count	223 Count
1774170918	499 Count	386 Count	223 Count
1774169117	498 Count	385 Count	223 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)