PenangAPRS Track

My position About ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780197214	352 Count	316 Count	238 Count
1780195420	350 Count	315 Count	237 Count
1780193619	348 Count	313 Count	236 Count
1780191818	346 Count	311 Count	235 Count
1780190018	344 Count	309 Count	234 Count
1780188217	341 Count	306 Count	232 Count
1780186416	339 Count	304 Count	231 Count
1780184616	337 Count	302 Count	230 Count
1780182815	335 Count	300 Count	229 Count
1780181014	333 Count	298 Count	228 Count
1780179213	330 Count	295 Count	226 Count
1780177413	328 Count	293 Count	225 Count
1780175612	326 Count	291 Count	224 Count
1780173821	324 Count	289 Count	223 Count
1780172020	322 Count	287 Count	222 Count
1780170220	319 Count	285 Count	220 Count
1780168419	317 Count	283 Count	219 Count
1780166618	315 Count	281 Count	218 Count
1780164818	313 Count	279 Count	217 Count
1780163017	311 Count	277 Count	216 Count
1780161216	308 Count	275 Count	214 Count
1780159415	294 Count	234 Count	201 Count
1780157615	289 Count	206 Count	197 Count
1780155814	287 Count	204 Count	196 Count
1780154013	285 Count	202 Count	195 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)