PenangAPRS Track

My position About ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786391823	10 Count	509 Count
1786390020	9 Count	465 Count
1786388216	8 Count	424 Count
1786386413	7 Count	383 Count
1786384610	6 Count	341 Count
1786382806	5 Count	289 Count
1786381003	4 Count	233 Count
1786379233	3 Count	184 Count
1786377429	2 Count	136 Count
1786375626	1 Count	95 Count
1786373823	0 Count	36 Count
1786372019	17 Count	1011 Count
1786370216	16 Count	972 Count
1786368413	15 Count	927 Count
1786366609	14 Count	890 Count
1786364806	13 Count	841 Count
1786363003	12 Count	796 Count
1786361231	11 Count	747 Count
1786359428	10 Count	694 Count
1786357625	9 Count	642 Count
1786355821	8 Count	582 Count
1786354018	7 Count	521 Count
1786352215	6 Count	466 Count
1786350411	5 Count	415 Count
1786348608	4 Count	363 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)