PenangAPRS Track

My position About ☰

reset

EB5KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790356584	6 Count	626 Count
1790354780	5 Count	508 Count
1790352977	4 Count	395 Count
1790351174	3 Count	271 Count
1790349371	2 Count	187 Count
1790347568	1 Count	97 Count
1790345765	0 Count	0 Count
1790343997	9 Count	956 Count
1790342194	8 Count	847 Count
1790340391	7 Count	728 Count
1790338588	6 Count	632 Count
1790336785	5 Count	542 Count
1790334982	4 Count	461 Count
1790333179	3 Count	382 Count
1790331376	2 Count	310 Count
1790329573	1 Count	210 Count
1790327770	0 Count	106 Count
1790325967	9 Count	1071 Count
1790324164	8 Count	957 Count
1790322397	7 Count	848 Count
1790320594	6 Count	692 Count
1790318791	5 Count	567 Count
1790316988	4 Count	437 Count
1790315185	3 Count	301 Count
1790313382	2 Count	222 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)