PenangAPRS Track

My position About ☰

reset

SR2BC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786400089	179 Count	936 Count	96 Count
1786398289	177 Count	928 Count	95 Count
1786396488	175 Count	920 Count	94 Count
1786394687	173 Count	911 Count	93 Count
1786392886	170 Count	900 Count	91 Count
1786389285	166 Count	882 Count	89 Count
1786385683	162 Count	865 Count	87 Count
1786383881	159 Count	856 Count	85 Count
1786382081	157 Count	850 Count	84 Count
1786380279	155 Count	843 Count	83 Count
1786377823	153 Count	833 Count	82 Count
1786376022	151 Count	827 Count	81 Count
1786372421	147 Count	814 Count	79 Count
1786370620	145 Count	805 Count	78 Count
1786365217	138 Count	788 Count	74 Count
1786363416	136 Count	783 Count	73 Count
1786361615	134 Count	775 Count	72 Count
1786358014	129 Count	761 Count	69 Count
1786356196	127 Count	754 Count	68 Count
1786354396	125 Count	748 Count	67 Count
1786352595	123 Count	742 Count	66 Count
1786350794	120 Count	730 Count	64 Count
1786348993	118 Count	721 Count	63 Count
1786343591	114 Count	710 Count	62 Count
1786341790	112 Count	699 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)