PenangAPRS Track

My position About ☰

reset

ON4CDR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON4CDR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1786398870	232 Count	526 Count
1786397967	214 Count	488 Count
1786397064	196 Count	437 Count
1786396161	179 Count	370 Count
1786395255	159 Count	319 Count
1786394353	141 Count	279 Count
1786393449	124 Count	234 Count
1786392546	103 Count	195 Count
1786391643	70 Count	160 Count
1786390740	51 Count	110 Count
1786389837	34 Count	68 Count
1786388934	16 Count	36 Count
1786388030	346 Count	1022 Count
1786387127	329 Count	995 Count
1786386224	310 Count	941 Count
1786385322	294 Count	898 Count
1786384418	278 Count	862 Count
1786383515	260 Count	804 Count
1786382612	243 Count	754 Count
1786381783	226 Count	697 Count
1786380880	208 Count	640 Count
1786379977	188 Count	585 Count
1786379074	170 Count	535 Count
1786378171	154 Count	477 Count
1786377268	138 Count	421 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)