PenangAPRS Track

My position About ☰

reset

WB6ETY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1769829510	1372	731	365	725	42
1769829189	1372	731	365	725	31
1769828790	1374	731	354	725	31
1769828071	1372	730	354	725	29
1769827389	1372	730	359	720	39
1769827350	1372	730	365	725	34
1769826630	1372	728	359	725	35
1769825910	1374	728	359	725	36
1769825589	1372	728	354	720	35
1769825190	1372	727	359	725	37
1769824470	1372	727	354	720	40
1769823789	1372	726	354	720	37
1769823751	1372	726	359	720	35
1769822311	1371	726	354	720	39
1769821989	1372	726	359	720	33
1769820871	1372	725	354	720	36
1769820189	1372	725	354	716	29
1769820150	1372	724	354	720	44
1769818389	1372	722	354	716	33
1769817270	1372	718	354	712	43
1769816589	1372	715	354	707	47
1769816549	1371	715	349	712	33
1769815831	1372	713	354	707	37
1769815110	1372	712	354	707	44
1769814789	1372	712	349	702	39

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)