PenangAPRS Track

My position About ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773736619	32 Count	373 Count	27 Count
1773734818	28 Count	339 Count	24 Count
1773733018	21 Count	266 Count	18 Count
1773731217	15 Count	209 Count	13 Count
1773729416	11 Count	129 Count	10 Count
1773727616	5 Count	51 Count	5 Count
1773725815	89 Count	1058 Count	71 Count
1773724015	83 Count	1000 Count	66 Count
1773722214	78 Count	948 Count	62 Count
1773720414	75 Count	900 Count	60 Count
1773718613	70 Count	847 Count	56 Count
1773716812	66 Count	797 Count	53 Count
1773715021	63 Count	737 Count	51 Count
1773713219	59 Count	690 Count	48 Count
1773711418	54 Count	626 Count	44 Count
1773709617	47 Count	566 Count	38 Count
1773707816	41 Count	509 Count	33 Count
1773706015	33 Count	423 Count	26 Count
1773704215	30 Count	375 Count	24 Count
1773702414	25 Count	318 Count	20 Count
1773700614	21 Count	254 Count	17 Count
1773698813	17 Count	194 Count	14 Count
1773697013	10 Count	143 Count	8 Count
1773695212	5 Count	87 Count	4 Count
1773693418	1 Count	42 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)