PenangAPRS Track

My position About ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769805479	23 Count	111 Count	20 Count
1769803679	11 Count	63 Count	9 Count
1769801878	7 Count	31 Count	6 Count
1769798277	160 Count	1008 Count	115 Count
1769796476	156 Count	970 Count	112 Count
1769794676	153 Count	920 Count	110 Count
1769792875	148 Count	895 Count	106 Count
1769791074	139 Count	867 Count	98 Count
1769789274	132 Count	830 Count	92 Count
1769787473	120 Count	800 Count	81 Count
1769785672	117 Count	769 Count	79 Count
1769783878	108 Count	745 Count	75 Count
1769782077	105 Count	723 Count	73 Count
1769780277	101 Count	701 Count	70 Count
1769778476	98 Count	680 Count	68 Count
1769776676	92 Count	649 Count	63 Count
1769773074	85 Count	592 Count	58 Count
1769771274	81 Count	566 Count	55 Count
1769769473	76 Count	537 Count	51 Count
1769767673	73 Count	504 Count	49 Count
1769765872	71 Count	484 Count	48 Count
1769764072	66 Count	446 Count	44 Count
1769762277	57 Count	412 Count	40 Count
1769760477	52 Count	364 Count	36 Count
1769758676	48 Count	332 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)