PenangAPRS Track

My position About ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790292601	12 Count	499 Count
1790290800	8 Count	314 Count
1790289000	4 Count	156 Count
1790287183	26 Count	1112 Count
1790285382	21 Count	933 Count
1790283582	19 Count	799 Count
1790281767	14 Count	663 Count
1790279956	12 Count	495 Count
1790278144	6 Count	312 Count
1790276431	4 Count	184 Count
1790274616	21 Count	1152 Count
1790272816	19 Count	995 Count
1790271005	15 Count	796 Count
1790269188	14 Count	689 Count
1790267373	9 Count	445 Count
1790265573	5 Count	277 Count
1790263762	26 Count	1044 Count
1790261962	16 Count	855 Count
1790260146	14 Count	725 Count
1790258342	10 Count	546 Count
1790256533	5 Count	320 Count
1790254784	4 Count	198 Count
1790252968	23 Count	1161 Count
1790251167	22 Count	972 Count
1790249366	16 Count	876 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)