PenangAPRS Track

My position About ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773754872	96 Count	676 Count	81 Count
1773753971	94 Count	659 Count	80 Count
1773753071	91 Count	628 Count	78 Count
1773752170	84 Count	597 Count	72 Count
1773751270	81 Count	567 Count	70 Count
1773750377	79 Count	546 Count	69 Count
1773749468	76 Count	517 Count	67 Count
1773747666	55 Count	438 Count	48 Count
1773746764	41 Count	383 Count	35 Count
1773745864	32 Count	331 Count	27 Count
1773744963	22 Count	256 Count	18 Count
1773744062	10 Count	176 Count	7 Count
1773742261	4 Count	85 Count	3 Count
1773741360	1 Count	42 Count	1 Count
1773740459	117 Count	1015 Count	79 Count
1773739559	114 Count	968 Count	77 Count
1773738658	111 Count	913 Count	75 Count
1773737757	105 Count	846 Count	70 Count
1773736857	103 Count	790 Count	69 Count
1773735956	100 Count	752 Count	67 Count
1773735055	96 Count	695 Count	64 Count
1773734176	90 Count	665 Count	63 Count
1773732369	86 Count	596 Count	61 Count
1773731468	83 Count	554 Count	59 Count
1773730567	76 Count	515 Count	53 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)