PenangAPRS Track

My position About ☰

reset

PD1NL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD1NL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773767704	173 Count	123 Count
1773765901	172 Count	123 Count
1773764098	171 Count	123 Count
1773762295	170 Count	123 Count
1773760492	169 Count	123 Count
1773758689	168 Count	122 Count
1773756885	167 Count	121 Count
1773755082	166 Count	121 Count
1773753279	165 Count	121 Count
1773751476	164 Count	121 Count
1773749673	163 Count	121 Count
1773747870	162 Count	121 Count
1773746103	161 Count	121 Count
1773744300	160 Count	115 Count
1773742497	159 Count	111 Count
1773740694	158 Count	111 Count
1773738891	157 Count	111 Count
1773737088	156 Count	111 Count
1773735285	155 Count	111 Count
1773733482	154 Count	111 Count
1773731679	153 Count	111 Count
1773729876	152 Count	104 Count
1773728073	151 Count	101 Count
1773726269	150 Count	101 Count
1773724502	149 Count	101 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)