PenangAPRS Track

My position About ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1764952866	448 Count	236 Count	139 Count
1764951963	445 Count	234 Count	138 Count
1764951053	440 Count	230 Count	136 Count
1764950146	437 Count	229 Count	135 Count
1764949241	432 Count	226 Count	133 Count
1764948335	429 Count	223 Count	132 Count
1764947429	425 Count	222 Count	131 Count
1764946524	422 Count	219 Count	130 Count
1764945618	418 Count	216 Count	129 Count
1764944712	412 Count	212 Count	125 Count
1764943806	408 Count	208 Count	124 Count
1764942900	401 Count	201 Count	120 Count
1764941994	394 Count	195 Count	116 Count
1764941089	389 Count	191 Count	113 Count
1764940183	380 Count	183 Count	107 Count
1764939277	375 Count	178 Count	104 Count
1764938371	367 Count	169 Count	99 Count
1764937465	361 Count	163 Count	95 Count
1764936559	356 Count	159 Count	93 Count
1764935653	350 Count	151 Count	89 Count
1764934747	346 Count	149 Count	88 Count
1764933842	340 Count	140 Count	84 Count
1764932934	334 Count	136 Count	81 Count
1764932028	330 Count	131 Count	79 Count
1764931679	328 Count	130 Count	79 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)