PenangAPRS Track

My position About ☰

reset

SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769767275	85 Count	702 Count
1769763436	79 Count	690 Count
1769761633	78 Count	678 Count
1769759830	77 Count	667 Count
1769758062	72 Count	656 Count
1769756259	71 Count	643 Count
1769754456	70 Count	633 Count
1769752652	69 Count	620 Count
1769750849	68 Count	609 Count
1769749046	67 Count	597 Count
1769747243	66 Count	586 Count
1769743637	64 Count	562 Count
1769741833	63 Count	550 Count
1769740030	62 Count	538 Count
1769738227	61 Count	527 Count
1769732852	54 Count	493 Count
1769729246	52 Count	469 Count
1769723837	49 Count	434 Count
1769722034	48 Count	423 Count
1769720231	47 Count	411 Count
1769718427	46 Count	399 Count
1769716625	45 Count	388 Count
1769711252	38 Count	354 Count
1769707646	36 Count	330 Count
1769705843	35 Count	319 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)