PenangAPRS Track

My position About ☰

reset

OK1OBR-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794319347	38 Count	26 Count	26 Count
1794317543	37 Count	26 Count	26 Count
1794315739	36 Count	26 Count	26 Count
1794313935	35 Count	26 Count	26 Count
1794312131	34 Count	26 Count	26 Count
1794310328	33 Count	26 Count	26 Count
1794308523	32 Count	26 Count	26 Count
1794306720	21 Count	16 Count	16 Count
1794304916	16 Count	12 Count	12 Count
1794303112	11 Count	8 Count	8 Count
1794301308	6 Count	4 Count	4 Count
1794299504	1 Count	0 Count	0 Count
1794298159	141 Count	1 Count	0 Count
1794296355	140 Count	1 Count	0 Count
1794294551	139 Count	1 Count	0 Count
1794292793	138 Count	1 Count	0 Count
1794290989	137 Count	1 Count	0 Count
1794289185	136 Count	1 Count	0 Count
1794287381	135 Count	0 Count	0 Count
1794285578	134 Count	0 Count	0 Count
1794283773	133 Count	0 Count	0 Count
1794281970	132 Count	0 Count	0 Count
1794280166	131 Count	0 Count	0 Count
1794278362	130 Count	0 Count	0 Count
1794276558	129 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)