PenangAPRS Track

My position About ☰

reset

F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794329954	598 Count	427 Count	421 Count
1794328149	595 Count	425 Count	419 Count
1794326344	592 Count	423 Count	417 Count
1794324539	589 Count	421 Count	415 Count
1794322735	586 Count	419 Count	413 Count
1794320930	578 Count	417 Count	411 Count
1794319232	575 Count	415 Count	409 Count
1794317427	572 Count	413 Count	407 Count
1794315623	569 Count	411 Count	405 Count
1794313818	566 Count	409 Count	403 Count
1794312013	563 Count	407 Count	401 Count
1794310208	560 Count	405 Count	399 Count
1794308403	557 Count	403 Count	397 Count
1794306597	554 Count	401 Count	395 Count
1794304792	551 Count	399 Count	393 Count
1794302988	548 Count	397 Count	391 Count
1794301183	545 Count	395 Count	389 Count
1794299378	542 Count	393 Count	387 Count
1794297573	539 Count	391 Count	385 Count
1794295768	536 Count	389 Count	383 Count
1794293963	533 Count	387 Count	381 Count
1794292157	530 Count	385 Count	379 Count
1794290353	527 Count	383 Count	377 Count
1794288548	524 Count	381 Count	375 Count
1794286743	521 Count	379 Count	373 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)