PenangAPRS Track

My position About ☰

reset

IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1780201766	237 Count	813 Count	46 Count
1780199962	235 Count	792 Count	45 Count
1780194594	225 Count	726 Count	42 Count
1780192791	222 Count	711 Count	40 Count
1780189182	217 Count	672 Count	37 Count
1780185575	213 Count	632 Count	35 Count
1780183771	210 Count	609 Count	33 Count
1780181967	208 Count	596 Count	32 Count
1780180163	205 Count	579 Count	30 Count
1780178359	202 Count	547 Count	28 Count
1780171188	192 Count	456 Count	26 Count
1780169385	190 Count	449 Count	25 Count
1780165776	187 Count	438 Count	24 Count
1780163972	185 Count	428 Count	23 Count
1780162169	184 Count	428 Count	23 Count
1780160365	183 Count	428 Count	23 Count
1780149585	173 Count	427 Count	23 Count
1780147781	171 Count	420 Count	22 Count
1780145977	170 Count	420 Count	22 Count
1780144174	169 Count	420 Count	22 Count
1780120767	148 Count	374 Count	18 Count
1780118963	147 Count	374 Count	18 Count
1780117159	146 Count	374 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)