PenangAPRS Track

My position About ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1769778630	14 Count	318 Count
1769776827	13 Count	309 Count
1769775024	12 Count	299 Count
1769773221	11 Count	248 Count
1769771418	10 Count	223 Count
1769769614	9 Count	199 Count
1769767811	8 Count	174 Count
1769766008	7 Count	163 Count
1769764240	6 Count	153 Count
1769762437	5 Count	135 Count
1769760634	4 Count	111 Count
1769758830	3 Count	93 Count
1769757027	1 Count	69 Count
1769755224	0 Count	31 Count
1769753420	53 Count	1002 Count
1769751617	52 Count	987 Count
1769749814	51 Count	968 Count
1769748011	50 Count	946 Count
1769746208	49 Count	928 Count
1769744405	48 Count	913 Count
1769742638	47 Count	902 Count
1769740835	46 Count	878 Count
1769739032	45 Count	865 Count
1769737229	44 Count	845 Count
1769735426	42 Count	834 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)