PenangAPRS Track

My position About ☰

reset

EC5CIA-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EC5CIA-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1794329180	120 Count	921 Count
1794327559	119 Count	903 Count
1794325938	118 Count	899 Count
1794324317	117 Count	895 Count
1794322697	116 Count	889 Count
1794321076	115 Count	886 Count
1794320545	114 Count	884 Count
1794318924	113 Count	880 Count
1794317303	112 Count	863 Count
1794315682	111 Count	861 Count
1794314062	110 Count	857 Count
1794312441	109 Count	824 Count
1794310820	108 Count	821 Count
1794309200	107 Count	819 Count
1794307579	106 Count	754 Count
1794305958	105 Count	672 Count
1794304337	104 Count	633 Count
1794302717	103 Count	628 Count
1794301096	102 Count	624 Count
1794299475	101 Count	595 Count
1794295344	100 Count	595 Count
1794293723	99 Count	554 Count
1794292103	98 Count	539 Count
1794291571	97 Count	539 Count
1794289951	96 Count	531 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)