PenangAPRS Track

My position About ☰

reset

KQ6DI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790299969	634	957	1040	799	58
1790298167	650	986	1072	798	57
1790297384	666	1000	1080	797	57
1790296368	666	1013	1098	796	57
1790294568	688	1040	1126	795	58
1790293785	698	1051	1134	794	57
1790292769	704	1068	1152	793	59
1790290967	709	1083	1170	792	61
1790290185	709	1082	1166	791	58
1790289167	709	1076	1162	790	57
1790287367	709	1077	1162	789	58
1790286585	709	1079	1166	788	58
1790285567	709	1083	1170	787	59
1790283767	709	1070	1157	786	58
1790282985	693	1058	1144	785	57
1790281968	688	1033	1116	784	57
1790280167	661	993	1072	783	58
1790279385	645	974	1054	782	57
1790278367	634	952	1031	781	58
1790276569	618	925	1004	780	56
1790275785	612	917	995	779	57
1790274767	612	905	982	778	56
1790272967	596	876	954	777	55
1790272185	580	859	936	776	56
1790271168	569	826	905	775	56

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)