PenangAPRS Track

My position About ☰

reset

TA4HJ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA4HJ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773726756	116 Count	442 Count
1773724953	115 Count	440 Count
1773723150	114 Count	438 Count
1773721347	113 Count	436 Count
1773719580	112 Count	434 Count
1773717777	111 Count	432 Count
1773715974	110 Count	430 Count
1773714171	109 Count	429 Count
1773712368	108 Count	428 Count
1773710565	107 Count	427 Count
1773708762	106 Count	425 Count
1773706958	105 Count	423 Count
1773705155	104 Count	421 Count
1773703352	103 Count	419 Count
1773701549	102 Count	417 Count
1773699746	101 Count	415 Count
1773697980	100 Count	413 Count
1773696177	99 Count	411 Count
1773694374	98 Count	409 Count
1773692571	97 Count	407 Count
1773690768	96 Count	405 Count
1773688965	95 Count	403 Count
1773687161	94 Count	401 Count
1773685358	93 Count	399 Count
1773683555	92 Count	397 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)