PenangAPRS Track

My position About ☰

reset

GM4HYG-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GM4HYG-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773749540	457 Count	456 Count	258 Count
1773748636	455 Count	455 Count	257 Count
1773747733	453 Count	454 Count	256 Count
1773746829	451 Count	453 Count	255 Count
1773745926	449 Count	452 Count	254 Count
1773745022	447 Count	451 Count	253 Count
1773744119	445 Count	450 Count	252 Count
1773743215	443 Count	449 Count	251 Count
1773742312	441 Count	448 Count	250 Count
1773741408	439 Count	447 Count	249 Count
1773740505	437 Count	446 Count	248 Count
1773739601	435 Count	445 Count	247 Count
1773737795	428 Count	438 Count	242 Count
1773736890	425 Count	435 Count	240 Count
1773735988	423 Count	433 Count	239 Count
1773735084	421 Count	431 Count	238 Count
1773734180	419 Count	429 Count	237 Count
1773733360	413 Count	427 Count	236 Count
1773732456	411 Count	425 Count	235 Count
1773731552	409 Count	423 Count	234 Count
1773730650	407 Count	421 Count	233 Count
1773729745	405 Count	419 Count	232 Count
1773728841	403 Count	417 Count	231 Count
1773727938	401 Count	415 Count	230 Count
1773727034	399 Count	413 Count	229 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)