PenangAPRS Track

My position About ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790300706	32 Count	432 Count	16 Count
1790298905	30 Count	401 Count	15 Count
1790297104	28 Count	364 Count	14 Count
1790295303	26 Count	335 Count	13 Count
1790293503	21 Count	298 Count	9 Count
1790291702	19 Count	265 Count	8 Count
1790289901	17 Count	233 Count	7 Count
1790288101	15 Count	202 Count	6 Count
1790286300	13 Count	166 Count	5 Count
1790284499	11 Count	135 Count	4 Count
1790282706	5 Count	106 Count	3 Count
1790280905	3 Count	75 Count	2 Count
1790279105	1 Count	34 Count	1 Count
1790277304	78 Count	1005 Count	45 Count
1790275503	76 Count	963 Count	44 Count
1790273702	74 Count	924 Count	43 Count
1790271902	69 Count	888 Count	39 Count
1790270101	67 Count	852 Count	38 Count
1790268300	65 Count	797 Count	37 Count
1790266499	63 Count	753 Count	36 Count
1790264699	61 Count	721 Count	35 Count
1790262898	59 Count	683 Count	34 Count
1790261105	53 Count	653 Count	33 Count
1790259304	51 Count	623 Count	32 Count
1790257503	49 Count	592 Count	31 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)