PenangAPRS Track

My position About ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1792735365	121 Count	957 Count	110 Count
1792733565	113 Count	864 Count	103 Count
1792731764	102 Count	778 Count	93 Count
1792729963	92 Count	680 Count	84 Count
1792728163	80 Count	534 Count	73 Count
1792726362	69 Count	460 Count	63 Count
1792724561	59 Count	387 Count	54 Count
1792722761	49 Count	323 Count	45 Count
1792720969	39 Count	251 Count	36 Count
1792719168	28 Count	182 Count	26 Count
1792717367	18 Count	122 Count	17 Count
1792715567	8 Count	55 Count	8 Count
1792713766	148 Count	1003 Count	135 Count
1792711964	139 Count	940 Count	127 Count
1792710164	126 Count	864 Count	115 Count
1792708363	116 Count	798 Count	106 Count
1792706562	106 Count	738 Count	97 Count
1792704762	96 Count	675 Count	88 Count
1792702961	86 Count	605 Count	79 Count
1792701161	76 Count	544 Count	70 Count
1792699367	66 Count	480 Count	61 Count
1792697567	56 Count	414 Count	52 Count
1792695766	46 Count	345 Count	43 Count
1792693965	36 Count	281 Count	34 Count
1792692165	24 Count	216 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)