PenangAPRS Track

My position About ☰

reset

OK4RS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK4RS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780213827	491 Count	65 Count	58 Count
1780212024	490 Count	65 Count	58 Count
1780210221	489 Count	65 Count	58 Count
1780208418	488 Count	65 Count	58 Count
1780206614	487 Count	65 Count	58 Count
1780204811	486 Count	65 Count	58 Count
1780203008	485 Count	65 Count	58 Count
1780201205	484 Count	65 Count	58 Count
1780199402	483 Count	65 Count	58 Count
1780197599	482 Count	65 Count	58 Count
1780195795	481 Count	65 Count	58 Count
1780193992	480 Count	65 Count	58 Count
1780170625	467 Count	65 Count	58 Count
1780168822	466 Count	65 Count	58 Count
1780167019	465 Count	65 Count	58 Count
1780165216	464 Count	65 Count	58 Count
1780163413	463 Count	65 Count	58 Count
1780161610	462 Count	65 Count	58 Count
1780159806	461 Count	65 Count	58 Count
1780158003	460 Count	65 Count	58 Count
1780156200	459 Count	65 Count	58 Count
1780154397	458 Count	65 Count	58 Count
1780152594	457 Count	65 Count	58 Count
1780150791	456 Count	65 Count	58 Count
1780149025	455 Count	65 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)