PenangAPRS Track

My position About ☰

reset

EB5BZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790297819	9 Count	939 Count
1790295774	8 Count	849 Count
1790293728	7 Count	754 Count
1790291683	6 Count	646 Count
1790290532	5 Count	604 Count
1790288487	4 Count	515 Count
1790286442	3 Count	410 Count
1790284397	2 Count	325 Count
1790282352	1 Count	236 Count
1790280307	0 Count	133 Count
1790278262	7 Count	1033 Count
1790276217	6 Count	914 Count
1790274172	5 Count	818 Count
1790272127	4 Count	702 Count
1790270081	3 Count	567 Count
1790268932	2 Count	495 Count
1790266887	1 Count	353 Count
1790264841	0 Count	183 Count
1790262796	5 Count	1018 Count
1790260751	4 Count	835 Count
1790258706	3 Count	662 Count
1790256662	2 Count	512 Count
1790254617	1 Count	382 Count
1790252572	0 Count	186 Count
1790250527	7 Count	1178 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)