PenangAPRS Track

My position About ☰

reset

MB7ULR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7ULR. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1769812888	778 Count	458 Count	303 Count
1769809287	775 Count	455 Count	301 Count
1769805687	772 Count	452 Count	299 Count
1769802086	769 Count	449 Count	297 Count
1769798485	766 Count	446 Count	295 Count
1769794884	763 Count	443 Count	293 Count
1769791283	760 Count	440 Count	291 Count
1769787683	758 Count	438 Count	290 Count
1769784082	755 Count	435 Count	288 Count
1769780481	752 Count	432 Count	286 Count
1769776881	749 Count	429 Count	284 Count
1769773280	747 Count	427 Count	283 Count
1769769679	744 Count	424 Count	281 Count
1769766078	741 Count	421 Count	279 Count
1769762478	738 Count	418 Count	277 Count
1769758877	735 Count	415 Count	275 Count
1769755276	732 Count	412 Count	273 Count
1769751675	729 Count	409 Count	271 Count
1769748075	726 Count	406 Count	269 Count
1769744474	723 Count	403 Count	267 Count
1769740873	720 Count	400 Count	265 Count
1769737272	717 Count	397 Count	263 Count
1769733671	714 Count	394 Count	261 Count
1769730071	711 Count	391 Count	259 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)