PenangAPRS Track

My position About ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786413343	214 Count	367 Count	47 Count
1786411540	213 Count	367 Count	47 Count
1786409737	212 Count	367 Count	47 Count
1786407934	211 Count	367 Count	47 Count
1786402525	208 Count	367 Count	47 Count
1786398919	206 Count	367 Count	47 Count
1786397115	205 Count	367 Count	47 Count
1786395312	204 Count	367 Count	47 Count
1786393509	203 Count	367 Count	47 Count
1786391706	202 Count	367 Count	47 Count
1786389903	201 Count	367 Count	47 Count
1786388100	200 Count	367 Count	47 Count
1786386297	199 Count	367 Count	47 Count
1786382691	197 Count	367 Count	47 Count
1786380888	196 Count	367 Count	47 Count
1786379085	195 Count	367 Count	47 Count
1786377282	194 Count	367 Count	47 Count
1786375479	193 Count	367 Count	47 Count
1786373676	192 Count	367 Count	47 Count
1786371873	191 Count	367 Count	47 Count
1786370070	184 Count	361 Count	41 Count
1786368267	183 Count	361 Count	41 Count
1786366464	182 Count	361 Count	41 Count
1786364660	181 Count	361 Count	41 Count
1786362857	180 Count	361 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)