PenangAPRS Track

My position About ☰

reset

F6JON-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6JON-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794335061	193 Count	696 Count	103 Count
1794334457	191 Count	690 Count	102 Count
1794333852	190 Count	682 Count	102 Count
1794333248	188 Count	673 Count	102 Count
1794332644	180 Count	660 Count	95 Count
1794332036	165 Count	640 Count	81 Count
1794331432	162 Count	632 Count	80 Count
1794330827	153 Count	620 Count	73 Count
1794330223	151 Count	610 Count	73 Count
1794329618	149 Count	604 Count	73 Count
1794329014	148 Count	598 Count	73 Count
1794328409	147 Count	591 Count	73 Count
1794327805	144 Count	587 Count	73 Count
1794327200	140 Count	576 Count	73 Count
1794326596	135 Count	555 Count	73 Count
1794325992	131 Count	549 Count	73 Count
1794325387	130 Count	544 Count	73 Count
1794324783	116 Count	527 Count	60 Count
1794324176	98 Count	503 Count	44 Count
1794323572	96 Count	497 Count	43 Count
1794322968	94 Count	489 Count	42 Count
1794322363	92 Count	483 Count	42 Count
1794321759	90 Count	473 Count	41 Count
1794321155	89 Count	465 Count	41 Count
1794320549	86 Count	459 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)