PenangAPRS Track

My position About ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794333090	46 Count	706 Count	14 Count
1794331289	44 Count	678 Count	13 Count
1794329488	43 Count	654 Count	13 Count
1794327687	41 Count	632 Count	12 Count
1794325887	38 Count	611 Count	10 Count
1794324086	37 Count	589 Count	10 Count
1794322285	36 Count	568 Count	10 Count
1794320484	35 Count	538 Count	10 Count
1794318692	30 Count	520 Count	10 Count
1794316891	28 Count	497 Count	9 Count
1794315090	27 Count	471 Count	9 Count
1794313289	25 Count	439 Count	8 Count
1794311489	24 Count	405 Count	8 Count
1794309688	21 Count	363 Count	6 Count
1794307887	20 Count	325 Count	6 Count
1794306086	19 Count	299 Count	6 Count
1794304286	18 Count	269 Count	6 Count
1794302485	17 Count	240 Count	6 Count
1794300684	16 Count	215 Count	6 Count
1794298883	15 Count	191 Count	6 Count
1794297090	10 Count	166 Count	6 Count
1794295290	8 Count	129 Count	5 Count
1794293489	5 Count	103 Count	3 Count
1794291688	2 Count	75 Count	1 Count
1794289888	1 Count	38 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)