PenangAPRS Track

My position About ☰

reset

EA5URV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5URV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769816427	8 Count	842 Count
1769813124	7 Count	772 Count
1769809821	6 Count	689 Count
1769806521	5 Count	607 Count
1769803217	4 Count	492 Count
1769798138	2 Count	302 Count
1769794834	1 Count	190 Count
1769791531	0 Count	87 Count
1769788227	7 Count	1032 Count
1769784924	6 Count	897 Count
1769781621	5 Count	798 Count
1769778317	4 Count	651 Count
1769776532	3 Count	547 Count
1769773229	2 Count	394 Count
1769769925	1 Count	250 Count
1769766622	0 Count	124 Count
1769763318	13 Count	1083 Count
1769760015	12 Count	972 Count
1769756336	10 Count	838 Count
1769753033	9 Count	733 Count
1769749730	8 Count	611 Count
1769746426	7 Count	537 Count
1769743123	6 Count	471 Count
1769739819	5 Count	402 Count
1769736516	4 Count	324 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)