PenangAPRS Track

My position About ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780197508	131 Count	17 Count	17 Count
1780195707	130 Count	17 Count	17 Count
1780193906	129 Count	17 Count	17 Count
1780192106	128 Count	17 Count	17 Count
1780190305	127 Count	17 Count	17 Count
1780188504	126 Count	17 Count	17 Count
1780186704	125 Count	17 Count	17 Count
1780184903	124 Count	17 Count	17 Count
1780183102	123 Count	17 Count	17 Count
1780181301	122 Count	17 Count	17 Count
1780157908	109 Count	17 Count	17 Count
1780156107	108 Count	17 Count	17 Count
1780154307	107 Count	17 Count	17 Count
1780152506	106 Count	17 Count	17 Count
1780150705	105 Count	17 Count	17 Count
1780148904	104 Count	17 Count	17 Count
1780147104	99 Count	13 Count	13 Count
1780145303	98 Count	13 Count	13 Count
1780143502	97 Count	13 Count	13 Count
1780141702	96 Count	13 Count	13 Count
1780139901	95 Count	13 Count	13 Count
1780138100	94 Count	13 Count	13 Count
1780136306	93 Count	13 Count	13 Count
1780134505	92 Count	13 Count	13 Count
1780132705	91 Count	13 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)