PenangAPRS Track

My position About ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794337345	24 Count	260 Count	14 Count
1794335545	21 Count	221 Count	12 Count
1794333752	14 Count	171 Count	10 Count
1794331951	11 Count	140 Count	8 Count
1794330150	8 Count	99 Count	6 Count
1794326549	2 Count	36 Count	2 Count
1794324748	76 Count	1031 Count	54 Count
1794322948	73 Count	982 Count	52 Count
1794321146	70 Count	944 Count	50 Count
1794319346	67 Count	901 Count	48 Count
1794317545	62 Count	838 Count	44 Count
1794315744	57 Count	754 Count	40 Count
1794313944	54 Count	679 Count	38 Count
1794313631	49 Count	675 Count	38 Count
1794311831	45 Count	588 Count	35 Count
1794310030	40 Count	501 Count	31 Count
1794308237	30 Count	375 Count	26 Count
1794306436	24 Count	297 Count	21 Count
1794304635	18 Count	219 Count	16 Count
1794302835	12 Count	139 Count	11 Count
1794301034	5 Count	72 Count	5 Count
1794299233	84 Count	1038 Count	68 Count
1794297432	78 Count	959 Count	63 Count
1794295632	70 Count	852 Count	56 Count
1794293831	64 Count	774 Count	51 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)