PenangAPRS Track

My position About ☰

reset

OR7F-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OR7F-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1735222750	9	1219	3000	72
1735222142	14	1219	3000	72
1735221838	9	1219	3000	72
1735221535	14	1219	3000	72
1735221230	13	1219	2998	72
1735220926	13	1219	2998	72
1735220622	13	1220	2997	72
1735220318	13	1220	2996	72
1735220014	9	1219	2996	72
1735219710	14	1220	2994	72
1735219405	14	1220	2993	72
1735219102	14	1219	2992	72
1735218798	14	1219	2991	72
1735218494	15	1220	2990	72
1735218190	15	1219	2989	72
1735217886	15	1219	2989	72
1735217278	14	1219	2986	72
1735216974	9	1219	2986	72
1735216671	9	1219	2985	72
1735216366	14	1219	2985	71
1735216062	14	1219	2984	71
1735215758	15	1219	2983	71
1735215454	16	1219	2983	71
1735215150	9	1219	2982	71
1735214542	16	1220	2980	71

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)