PenangAPRS Track

My position About ☰

reset

SQ9IWE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IWE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790302647	13 Count	854 Count
1790300847	11 Count	707 Count
1790299047	7 Count	563 Count
1790297247	6 Count	421 Count
1790295446	5 Count	288 Count
1790293645	3 Count	141 Count
1790291846	34 Count	1075 Count
1790290046	33 Count	952 Count
1790288245	32 Count	829 Count
1790286444	30 Count	688 Count
1790284646	26 Count	564 Count
1790282845	25 Count	439 Count
1790281045	24 Count	305 Count
1790279244	22 Count	177 Count
1790277445	23 Count	1026 Count
1790275645	12 Count	879 Count
1790273844	7 Count	712 Count
1790272043	5 Count	583 Count
1790270245	1 Count	362 Count
1790268444	0 Count	210 Count
1790266643	13 Count	1205 Count
1790264842	11 Count	805 Count
1790263044	7 Count	565 Count
1790261243	6 Count	408 Count
1790259443	5 Count	221 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)