PenangAPRS Track

My position About ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1773727270	116 Count	285 Count
1773725844	112 Count	282 Count
1773724163	111 Count	279 Count
1773722482	110 Count	276 Count
1773720801	109 Count	274 Count
1773719120	108 Count	271 Count
1773717440	107 Count	268 Count
1773715759	106 Count	265 Count
1773714078	105 Count	262 Count
1773712398	104 Count	254 Count
1773710716	103 Count	251 Count
1773709036	102 Count	248 Count
1773707355	101 Count	246 Count
1773705673	99 Count	243 Count
1773704242	95 Count	240 Count
1773702560	94 Count	237 Count
1773700879	93 Count	234 Count
1773699199	92 Count	232 Count
1773697518	91 Count	229 Count
1773695837	90 Count	226 Count
1773694157	89 Count	223 Count
1773692475	88 Count	220 Count
1773690795	87 Count	212 Count
1773689114	86 Count	209 Count
1773687433	85 Count	206 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)