PenangAPRS Track

My position About ☰

reset

F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1794340130	155 Count	811 Count	107 Count
1794336540	149 Count	765 Count	102 Count
1794332936	144 Count	723 Count	98 Count
1794329332	120 Count	663 Count	78 Count
1794325728	98 Count	611 Count	67 Count
1794322124	84 Count	550 Count	54 Count
1794318520	75 Count	512 Count	46 Count
1794314940	57 Count	426 Count	29 Count
1794311335	40 Count	337 Count	21 Count
1794307731	39 Count	267 Count	21 Count
1794304127	35 Count	184 Count	19 Count
1794300523	15 Count	76 Count	0 Count
1794296918	0 Count	0 Count	0 Count
1794293340	165 Count	941 Count	101 Count
1794289736	155 Count	886 Count	97 Count
1794286131	148 Count	857 Count	91 Count
1794282527	141 Count	835 Count	85 Count
1794278922	134 Count	813 Count	79 Count
1794275318	129 Count	785 Count	75 Count
1794271743	122 Count	758 Count	69 Count
1794268138	116 Count	737 Count	64 Count
1794264534	111 Count	716 Count	60 Count
1794260930	110 Count	693 Count	60 Count
1794257325	109 Count	664 Count	60 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)