PenangAPRS Track

My position About ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764958429	4 Count	470 Count
1764956625	3 Count	383 Count
1764954822	2 Count	286 Count
1764953019	1 Count	198 Count
1764951216	0 Count	104 Count
1764949413	7 Count	1054 Count
1764947609	6 Count	961 Count
1764945844	5 Count	841 Count
1764944041	4 Count	741 Count
1764942237	3 Count	629 Count
1764940434	2 Count	492 Count
1764938631	1 Count	339 Count
1764936828	0 Count	157 Count
1764935025	5 Count	1063 Count
1764933222	4 Count	882 Count
1764931418	3 Count	696 Count
1764929615	2 Count	513 Count
1764927812	1 Count	345 Count
1764926009	0 Count	155 Count
1764924248	6 Count	1045 Count
1764922444	5 Count	864 Count
1764920641	4 Count	692 Count
1764918838	3 Count	549 Count
1764917035	2 Count	408 Count
1764915232	1 Count	277 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)