PenangAPRS Track

My position About ☰

reset

SP3QDU-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3QDU-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794341851	985 Count	487 Count	103 Count
1794340950	984 Count	487 Count	103 Count
1794340049	983 Count	487 Count	103 Count
1794339149	982 Count	487 Count	103 Count
1794338248	981 Count	487 Count	103 Count
1794337347	980 Count	487 Count	103 Count
1794336465	975 Count	487 Count	103 Count
1794335564	974 Count	487 Count	103 Count
1794334664	973 Count	487 Count	103 Count
1794333763	972 Count	487 Count	103 Count
1794332862	971 Count	487 Count	103 Count
1794331961	970 Count	487 Count	103 Count
1794331060	969 Count	487 Count	103 Count
1794330159	968 Count	487 Count	103 Count
1794329258	967 Count	487 Count	103 Count
1794328359	966 Count	487 Count	103 Count
1794327457	965 Count	487 Count	103 Count
1794326558	964 Count	487 Count	103 Count
1794325655	963 Count	487 Count	103 Count
1794324754	962 Count	487 Count	103 Count
1794323853	961 Count	487 Count	103 Count
1794322953	960 Count	487 Count	103 Count
1794322052	959 Count	487 Count	103 Count
1794321151	958 Count	487 Count	103 Count
1794320250	957 Count	487 Count	103 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)