PenangAPRS Track

My position About ☰

reset

SQ2PDS-0 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2PDS-0. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794347962	15 Count	87 Count	12 Count
1794346161	10 Count	63 Count	8 Count
1794344361	6 Count	44 Count	5 Count
1794342560	2 Count	25 Count	2 Count
1794340759	198 Count	1004 Count	151 Count
1794333564	173 Count	908 Count	134 Count
1794331764	169 Count	887 Count	131 Count
1794329963	165 Count	855 Count	128 Count
1794328162	162 Count	832 Count	126 Count
1794326361	157 Count	811 Count	122 Count
1794324560	153 Count	786 Count	119 Count
1794320958	145 Count	739 Count	113 Count
1794319157	141 Count	711 Count	110 Count
1794315566	124 Count	665 Count	99 Count
1794313765	117 Count	636 Count	93 Count
1794311964	108 Count	600 Count	85 Count
1794310163	102 Count	570 Count	80 Count
1794308362	93 Count	519 Count	72 Count
1794304760	84 Count	459 Count	65 Count
1794302960	81 Count	430 Count	63 Count
1794301159	77 Count	404 Count	60 Count
1794299358	72 Count	378 Count	56 Count
1794297557	68 Count	350 Count	53 Count
1794293966	55 Count	294 Count	46 Count
1794292165	49 Count	266 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)