PenangAPRS Track

My position About ☰

reset

SQ9KFP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780189788	65 Count	645 Count
1780188887	64 Count	635 Count
1780187999	59 Count	624 Count
1780187099	58 Count	611 Count
1780186198	57 Count	597 Count
1780185298	56 Count	588 Count
1780184397	55 Count	577 Count
1780183496	54 Count	561 Count
1780182596	53 Count	550 Count
1780181695	52 Count	540 Count
1780180795	51 Count	529 Count
1780179894	50 Count	513 Count
1780178093	48 Count	489 Count
1780177193	47 Count	475 Count
1780176292	46 Count	462 Count
1780175391	45 Count	450 Count
1780174491	44 Count	437 Count
1780173590	43 Count	423 Count
1780172690	42 Count	408 Count
1780171789	41 Count	395 Count
1780170889	40 Count	385 Count
1780169988	39 Count	374 Count
1780168187	37 Count	348 Count
1780167286	36 Count	339 Count
1780165498	30 Count	317 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)