PenangAPRS Track

My position About ☰

reset

SP4XQE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4XQE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794335424	19 Count	40 Count	0 Count
1794334524	18 Count	40 Count	0 Count
1794333623	17 Count	39 Count	0 Count
1794332722	16 Count	36 Count	0 Count
1794331822	15 Count	35 Count	0 Count
1794330921	14 Count	33 Count	0 Count
1794330020	13 Count	31 Count	0 Count
1794329119	12 Count	28 Count	0 Count
1794328219	11 Count	26 Count	0 Count
1794327318	10 Count	24 Count	0 Count
1794326417	9 Count	22 Count	0 Count
1794325516	8 Count	20 Count	0 Count
1794324616	7 Count	18 Count	0 Count
1794323715	6 Count	16 Count	0 Count
1794322831	5 Count	14 Count	0 Count
1794321930	4 Count	12 Count	0 Count
1794321029	3 Count	12 Count	0 Count
1794320128	2 Count	9 Count	0 Count
1794319228	1 Count	5 Count	0 Count
1794318327	0 Count	1 Count	0 Count
1794317426	227 Count	1003 Count	55 Count
1794316526	226 Count	1000 Count	55 Count
1794315625	225 Count	996 Count	55 Count
1794314724	224 Count	992 Count	55 Count
1794313823	223 Count	990 Count	55 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)