PenangAPRS Track

My position About ☰

reset

SQ2WIT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WIT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1792735850	22 Count	50 Count	22 Count
1792734950	502 Count	1028 Count	477 Count
1792734049	472 Count	976 Count	448 Count
1792733148	436 Count	909 Count	413 Count
1792732248	416 Count	866 Count	394 Count
1792731347	387 Count	817 Count	366 Count
1792730446	367 Count	775 Count	347 Count
1792729546	318 Count	691 Count	299 Count
1792728645	290 Count	621 Count	272 Count
1792727744	265 Count	567 Count	248 Count
1792726843	244 Count	529 Count	228 Count
1792725943	222 Count	477 Count	207 Count
1792725042	206 Count	445 Count	192 Count
1792724156	182 Count	403 Count	173 Count
1792723255	166 Count	368 Count	158 Count
1792722355	147 Count	325 Count	140 Count
1792721454	125 Count	284 Count	119 Count
1792720553	105 Count	246 Count	100 Count
1792719653	90 Count	212 Count	86 Count
1792718752	70 Count	175 Count	67 Count
1792717851	56 Count	138 Count	54 Count
1792716951	33 Count	87 Count	32 Count
1792716050	17 Count	40 Count	17 Count
1792715150	518 Count	1014 Count	487 Count
1792714249	501 Count	980 Count	471 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)