PenangAPRS Track

My position About ☰

reset

SP2HCC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1790284569	749 Count	918 Count	528 Count
1790283068	748 Count	918 Count	528 Count
1790281567	747 Count	918 Count	528 Count
1790280067	746 Count	918 Count	528 Count
1790278566	745 Count	918 Count	528 Count
1790277065	744 Count	918 Count	528 Count
1790276489	743 Count	918 Count	528 Count
1790274988	742 Count	918 Count	528 Count
1790273487	741 Count	918 Count	528 Count
1790271985	740 Count	918 Count	528 Count
1790270485	739 Count	918 Count	528 Count
1790268984	738 Count	918 Count	528 Count
1790267483	737 Count	918 Count	528 Count
1790265982	736 Count	918 Count	528 Count
1790264481	735 Count	918 Count	528 Count
1790262980	734 Count	918 Count	528 Count
1790261479	733 Count	918 Count	528 Count
1790259978	724 Count	900 Count	520 Count
1790258478	723 Count	900 Count	520 Count
1790256976	718 Count	896 Count	516 Count
1790255476	717 Count	896 Count	516 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)