PenangAPRS Track

My position About ☰

reset

IN3EJX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IN3EJX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794361647	65 Count	392 Count
1794359844	64 Count	384 Count
1794358040	63 Count	376 Count
1794356237	62 Count	368 Count
1794354433	61 Count	361 Count
1794352630	60 Count	352 Count
1794350826	59 Count	344 Count
1794349022	58 Count	336 Count
1794347259	53 Count	328 Count
1794345455	52 Count	320 Count
1794343651	51 Count	311 Count
1794341848	50 Count	304 Count
1794340044	49 Count	296 Count
1794338241	48 Count	288 Count
1794336437	47 Count	279 Count
1794334634	46 Count	271 Count
1794332830	45 Count	262 Count
1794331027	44 Count	255 Count
1794329223	43 Count	248 Count
1794327420	42 Count	240 Count
1794325656	37 Count	232 Count
1794323852	36 Count	224 Count
1794322049	35 Count	217 Count
1794320245	34 Count	209 Count
1794318442	33 Count	202 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)