PenangAPRS Track

My position About ☰

reset

IT9IRS-PA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-PA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1792745460	16 Count	232 Count
1792743033	12 Count	175 Count
1792742429	11 Count	163 Count
1792740002	7 Count	125 Count
1792739405	6 Count	111 Count
1792737583	3 Count	60 Count
1792736979	2 Count	47 Count
1792736389	1 Count	24 Count
1792735769	0 Count	13 Count
1792735164	77 Count	1004 Count
1792734560	76 Count	982 Count
1792733955	75 Count	969 Count
1792733358	74 Count	961 Count
1792732746	73 Count	947 Count
1792732141	72 Count	938 Count
1792731544	71 Count	921 Count
1792730327	69 Count	893 Count
1792729722	68 Count	880 Count
1792729118	67 Count	867 Count
1792728513	66 Count	856 Count
1792727908	65 Count	844 Count
1792727319	64 Count	827 Count
1792724295	59 Count	769 Count
1792723683	58 Count	744 Count
1792722473	56 Count	731 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)